How To Clean Newly Laid Wall Tiles

Mix 1 part white vinegar to 4 parts water in a bucket or large spray bottle.

How to clean newly laid wall tiles.

Just be absolutely sure before you have a huge re do job in your bathroom before you can be given a certificate of compliance. A damp microfibre mop is better than a wet mop for a streak free clean avoid the use of cotton and sponge mops. Dampen a clean sponge and wring it out so that it s slightly damp. Remove traces of adhesive mortar on the tiles with a damp sponge that you ll rinse frequently.

Vacuum to remove dust. Wipe over each tile individually using one smooth pass flip the sponge and make another pass. Remove any remaining dust oils and grease from the wall with tsp tri sodium phosphate or an ammonia based cleanser. For a thorough clean use the miracle tile stone cleaner available from beaumont tiles with warm water and a damp microfibre mop.

Patch any holes or cracks with spackling compound and sand the entire surface with medium grit sandpaper. Rinse and wring between each tile. Scrape the wall to remove any texture and to create a flat surface. I simply searched tile safety in the bathroom there is a section about tiles and how they must comply with australian safety regulations and that some imported tiles do not meet this compliance.

Run a dry cloth over the tiles to remove any leftover and dry the floor. It is important to rinse the sponge as you go to avoid leaving traces of mortar difficult to remove once dry. When you re laying the tiles. Depending on the surface area you must cover use a mop or soft.

You can add more vinegar to make the mixture stronger if needed. The mop should grab the surface and lift off most daily grime with a little pressure. Wash the tiles again with plain water to remove any remaining vinegar.