There are several ways you can fix the bend in the garage door panel.
How to fix garage door panel.
Your garage panels are attached to each other and the track rollers.
Slide the new panel into position and line up the track rollers and hinges with the predrilled holes in the panel.
If it s a simple dent then this shouldn t be too hard to do.
Hammer out the bend.
Lift the panel you re replacing out of the door.
One of the most simple fixes you can do is hammering out the bend in the door.
This will make sure that the door does not spring open when you are working on it.
How to fix a bent garage door panel.
Bolt these into position with the hardware you removed earlier and your socket wrench.
Garage door seal is loose or broken.
Once this is done close the garage door holding it all the way down.
Removing the old panels.
To adjust the switch there is usually a screw on the motor unit that when turned will increase or decrease how far the door descends when closing.