How To Cover Vinyl Wall Panels

Buy faux stone item 139.

How to cover vinyl wall panels.

They also provide the walls with good protection from the elements and other sources of. Vinyl panels for the interior of your boat will add eye appeal and provide you with a tough wall surface. Vinyl on gypsum panels is typically 5 16 thick with a glossy paper coating. Use sandpaper on wall.

These vinyl coated walls have a shiny finish and there is often a printed design layer that is applied over the gypsum and under the shiny vinyl topcoat. A piece of 80 grit sandpaper wrapped around a block of wood will work. You must remove the battens clean the walls and fill the seams with drywall compound before papering. Go over the surface with a straight edge such as a credit card or ruler to push out any air bubbles that may have gotten trapped.

They can warp swell and peel causing damage to new coverings and if they are found in a. They work well to cover up the dings and smudges that grace the interior walls of any boat after a season of hard use. How to install fake stone wall panels do it yourself. However it is important that the vinyl covering be roughed up a little bit in order for the paint to adhere to the slick surface.

Manufacturers favor vog panels because they are lightweight and easy to install in factory settings. Work from the outside of the panel inward until you fully separate the laminate from the wall and then pull the laminate away. Do not use an electric sander for this operation. Normally you would not want to put any sandpaper onto the wall.

Step 4 remove the contact cement still on the wall by spraying the acetone directly on to the cement and scraping it away with the paint scraper after a minute. Easy step by step process for your interior design goals. Fabric or paper wallpaper provides another option for covering a vinyl wall. Vinyl wall panels especially in bathrooms are better off if they are removed as opposed to covered.

Manufactured homes usually use vog vinyl on gypsum wall panels rather than standard drywall. Carefully align the next panel to make sure that the pattern matches up with the panel beside it. They do not have tapered edges so installers use battens or strips to cover the seams where two panels meet.