Replace the face of the detector and listen for the chirping sound.
Hard wired smoke detector beeping intermittently.
Follow these steps to clean your detector.
On hardwired smoke detectors you may need to press and hold the reset button to make the chirping noise stop.
Remove the face of the detector.
It could be brace yourself that a spider has made itself cozy inside the alarm.
This chirping will continue for at least a week if you don t change the batteries.
If there s a lot of dust build up try using a mild detergent to help remove it.
Use a vacuum hose or a small brush to clean out all of the dust.
Remove the face of the alarm.
Take the smoke detector off its mounting bracket on the ceiling and disconnect the power cable plugged to the smoke detector.
Here s how you can clean the dust from out of your smoke detector to stop it from beeping for no reason.
3 take out its battery then press the test button holding it down for 15 seconds.
Turn off power to your wired smoke detector at the circuit box.
Replace the face of the detector and listen for the chirping sound.
If that smoke alarm is the culprit all of the beeping will stop.
All of the beeping can make it hard to think straight.
You can also use a mild detergent to eliminate any dust buildup.
Normally one smoke alarm is the cause of the beeping.
An alarm will sound for a short time then the alarm will silence.
You will want to stop the beeping as quickly as you can.
Typically smoke alarms are hardwired on the same circuit and once one smoke alarm begins beeping they will all start beeping.
If the smoke detector is beeping irregularly with no discernible pattern it s probably not the battery.
Smoke alarms are often out of sight and out of reach.
Then wait to see if the beeping stops.
You will want to go to each smoke alarm in your home and press the circle button on it to reset it.
Old or broken smoke detector.
Smoke detectors are built to chirp when the battery needs to be changed including backup batteries for hard wired alarms.